The assessor must be trained as per PUWER Regulation 9 Section 2.2 and have a full understanding of all plant vehicle operation that they are to assess. If you require further information, contact Ian Lumsden Tech IOSH, MIIRSM (ITSSAR Registered Instructor /Examiner ) by Email: Ian.firstname.lastname@example.org
Type of plant equipment?
If an operator has no proof of training held on record, they must not operate a forklift truck until proof of training Competancy has been proven?
Has the operator a valid certificate of training that has been passed or refreshed within the last three years?
Date of test or refresher course?
Has the operator an up to date authorisation to operate, signed and renewable annually?
Date of signed authorisation operate the plant vehicle?
Daily Safety Inspection
The operator completes the safety Pre-shift safety inspection correctly
The operator fully understands the capacity information plate?
The operator understands the correct fault reporting procedures?
If a fault has been found, the lift truck must be parked up in a safe place and the key removed. The fault must be made to a member of the management team.
Operator Safety & Observation
The operator mounts / dismounts correctly?
Uses the seatbelt correctly?
Keeps body parts within the confines of the vehicle?
Operator looks in the direction of travel?
Correct use of the horn when appropriate?
Follows the correct procedures for an "unattended" vehicle?
Operator had good all round safety observation?
Steering & Operating Controls
Starts and stops smoothly?
Correct use of the steering assistor?
Travels unintentionally in the wrong direction?
Brakes harshly / erratically?
Releases the parking brake prior to moving off?
Operator rides the foot brake?
Operates the hydraulic controls when the lift truck is in motion?
Rough use of hydraulic controls?
Operates and understands the controls?
Competency In Load Capacity
Operator matches load with the trucks capacity?
Operator checks the load for stability?
Manoeuvring & Transportation
Forks to high when traveling?
Forks to low when traveling?
Operating in reverse, looking in the direction of travel to the correct ratio?
Operates at a speed consistent with the type of load and working conditions?
Operator performs safe manoeuvring with the lift truck and load!
Stacking & de-stacking
Incorrect set down at a vertical face?
Operator applies the park brake when operating the hydraulics?
Operator applies neutral when operating the hydraulics?
Fork arms central under the load?
Fork arms not rubbing (entry / withdrawal)?
Fork tips touch the stack / load?
Forks / load not level?
Load correctly stacked?
Fork arms not fully inserted (undercut) ?
It is some times necessary to undercut a load due to the nature of where it is to be located. It must remain within the limits of the capacity plate.
The operator correctly applies the park brake?
The operator sets the direction lever to the neutral position?
The operator correctly apples forward tilt?
The operator correctly lowers the fork arms?
The manoeuvring wheels are in the straight position?
The operator switches off and removes the key?
Assessment Recommendations & Evaluations
Assessors evaluation of operator safety?
Date and time of assessment
Please note that this checklist template is a hypothetical example and provides only standard information. The template does not aim to replace, among other things, workplace, health and safety advice, medical advice, diagnosis or treatment, or any other applicable law. You should seek your professional advice to determine whether the use of such a checklist is appropriate in your workplace or jurisdiction.
Please, finish the registration to access the content of the checklist.